SET War Belt (3 Part System)


All Black D-Ring Cobra Buckles are standard on our War Belts.

All belts are made to order and current lead time is approximately 4 to 6 weeks.  


SKU: set-war-belt-3-part-system Category:



Waist size is the actual measurement around your belt loops, not pant size. Pant size varies and can be several inches different than the actual circumference of your waist. Measure your waist around your belt loops and order that size, we will take it from there.  


This may be the last “war belt” you ever buy. The S.E.T. War Belt project eliminated the bulk, weight, and redundancy of the traditional padded belt system. The result is a platform that is stronger, more versatile, lower profile, and lighter weight than anything else on the market.

The S.E.T. War Belt is a three part system that can be used with or without a pad.

1. A thin and light weight 1.5″ pant belt cut from one piece of Cordura laminate.  This reduces weight and bulk as compared to a belt made from nylon webbing.  The inner belt has 1.5″ loop tape sewn around the entire outside and overlaps by about 5″.

2. A low profile pad made from 4mm closed cell foam and heavy weight nylon mesh.  The pad has hook tape sewn to one side and loop tape sewn to the other.  The nylon mesh allows the belt to dry quickly.  The 4mm foam padding keeps a low profile, reduces weight, and keeps your gear as close to your body as possible.

3. A 1.75″ Cobra Duty Belt made from Type 13 parachute webbing and Cobra Buckle.  This is the part of the system that carries the load.  The Duty belt is constructed with two layers of webbing for the perfect balance of rigidity and flexibility and has our standard 2″ channel next to the Cobra buckle for clipping carabiners through.  On the back side is where it is different.  1″ reinforced hook tape is sewn down in 3″ increments creating MOLLE compatible channels.  This allows the operator to install gear without interfering with the hook and loop interface.  Of course any gear that would normally be used on a 1.75″ or 2″ belt can still be utilized.

Result: The result is a low profile, light weight, and rock solid load carrying system.  The inner belt, pad and outer belt are all secured to each other with 360 degrees of hook and loop.  You can run, jump, climb, crawl, squat etc, and this belt wont go anywhere.

Additional Features: To further increase the versatility of this system, we eliminated the hook and loop from the running end of the belt.   This allows for a greater adjustment range since the tail can be tucked back behind the belt or under a pouch.  The benefit to this is two fold.  The outer primary belt can be tightened down and used without the pad.  It can also be opened up bigger if the operator wants to wear the system over a bulky coat.  The padded belt’s heavy weight nylon mesh is naturally slip resistant.

What is included: This is a complete system which includes the inner pant belt, the pad, and the 1.75″ Cobra Duty belt.  Pouches are sold separately.


Additional information

Weight 20 oz